An image for the Rock64

To install it, dd the img.xz file to an SD card and boot the board with a serial cable attached.

Once the "Press enter to configure" message shows up in the terminal. Press enter
and configure IPv4 networking and set up a user. Now you should be able to ssh into the board
using the IP address that was shown to you at the end of the configuration process.

The snaps used to assemble this image are in the snaps/ subdir
The model assertion used for building the image is in the model-assertion/ subdir

The command used to build the image is:

ubuntu-image snap --channel edge --snap linux-arm64_4.19.0-13.14_arm64.snap --snap rock64_0.1_arm64.snap rock64.model

the sources for the snap packages can be found at:

https://github.com/ogra1/

DISCLAIMER !!!

Please note that all of these images are for development purpose only, they might not receive
regular security updates nor might bugs get fixed. Use them for evaluation and development purposes
but not in production or for any commercial projects